Can’t Boot from an ImageServer

When I can’t boot from an ImageServer, there are a few things that I immediately check to determine the cause and I shall go over them below.

Connectivity
Once an ImageServer is up and clients are appropriately connected, one of the causes that can stop you from booting is a loss of connectivity. You can tell this in two ways. A boot device not found or the proper boot of the local image on the PC.

The following two tabs change content below.
facebook-profile-picture

Stephan Pringle

Technology Support Specialist at Sipylus
About The Author: Stephan Pringle is an Information Technology Support Specialist. He covers hardware and software and provides tips for you to troubleshoot and repair issues on your own. In his spare time, he writes articles about the State of New York on his Hackintosh and HackBook and that has helped him to become the top contributor of the New York City section of Yahoo! Answers.
facebook-profile-picture

Latest posts by Stephan Pringle (see all)

facebook-profile-picture

Stephan Pringle

About The Author: Stephan Pringle is an Information Technology Support Specialist. He covers hardware and software and provides tips for you to troubleshoot and repair issues on your own. In his spare time, he writes articles about the State of New York on his Hackintosh and HackBook and that has helped him to become the top contributor of the New York City section of Yahoo! Answers.